Subject: | |
From: | |
Reply To: | |
Date: | Wed, 6 Apr 2005 15:43:01 -0600 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Kenny, unless the geometries are so tight that good yields are
impossible, fewer layers are always cheaper than more.
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Bloomquist, Ken
Sent: Wednesday, April 06, 2005 1:15 PM
To: [log in to unmask]
Subject: [TN] Board Cost
Good afternoon from the Great Northwet,
I was just asked to sign off on a PWB drawing that is a four layer board
with 3 oz. copper on each layer. According to engineering they have to
have 3 oz. copper or equivalent. They are small boards, about 2" X 3"
and not very dense. They have three through-hole circular connectors and
some wire entry holes. They are laid up in a tab route with eight
boards.
My question is, would it be cheaper to have a multilayer board with
additional 1 oz. copper layers to equal the 3 oz. they need or the way
they designed it?
Thanks,
KennyB
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text
in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at:
http://listserv.ipc.org/archives
Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100
ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|