Loc-tite(tm)?  A little dab will do ya'.

Regards,
Roger

-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Leticia Warner
Sent: Friday, March 04, 2005 10:19 AM
To: [log in to unmask]
Subject: [TN] Tilting Components

We have a component that is prone to tilting when running through the
wave solder process.  It is a through-hole resistor network that sits on
the edge of the board.  Due to the board space constraints, the customer
tolerance for tilting is practically none.  I've been trying to search
on the web for fixtures/accessories that could hold this component in
place, however, I'm having no luck.  Any thoughts?

--
Leticia Warner
Xytronics
8001 Mainland
San Antonio, TX  78250
[log in to unmask]

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e To
unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or
(re-start) delivery of Technet send e-mail to [log in to unmask]: SET
Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the
posts: send e-mail to [log in to unmask]: SET Technet Digest Search the
archives of previous posts at: http://listserv.ipc.org/archives Please
visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for
additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------