We have a component that is prone to tilting when running through the
wave solder process. It is a through-hole resistor network that sits
on the edge of the board. Due to the board space constraints, the
customer tolerance for tilting is practically none. I've been trying
to search on the web for fixtures/accessories that could hold this
component in place, however, I'm having no luck. Any thoughts?
--
Leticia Warner
Xytronics
8001 Mainland
San Antonio, TX 78250
[log in to unmask]
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------