Hi Pete,
You got some good answers to your question--but they are not differentiated
enough.
First, from purely a processing point of view, you would like to have the
least number of pads. For run-of-the-mill PCBs I would go with processing.
Second, from a reliability perspective, you need to differentiate between
vias [small diameter PTVs] and holes with larger diameters like component lead
holes (PTHs).
PTHs have a higher propensity of inner-layer separation, less for barrel
cracks. Innerlayer separation occur predominantly at layer 2, 3, n-2, and n-1—the
reason for this is the combined stresses from land rotation near the PCB
surfaces and barrel compression [the later shows up in analysis as resin
recession]. Barrel compression is the result of the 'hydro'-static pressures from the
expanding resin surrounding the barrel [think of a submerged submarine]. Thicker
plated barrels, smaller-diameter barrels and barrels with closely spaced pads
will resist this barrel compression better.
PTVs show more barrel cracks. Barrel cracks occur almost invariably at the
B-stage layers [higher resin content than laminates gives higher localized CTE-z
above Tg] near the PCB center [location of highest barrel stresses]. For
really thick PCBs [>150 mils] there is a high-stress center section of
near-uniform barrel stresses.
Thicker plated barrels, good quality drilling [smooth walls without fiber
rip-outs] and good quality ED copper [ductility, plating uniformity] will resist
barrel fractures better. The number of pads and their spacing has little
influence beyond simply replacing some of the high-CTE resin with low-CTE Cu.
Regards,
Werner Engelmaier
Engelmaier Associates, L.C.
Electronic Packaging, Interconnection and Reliability Consulting
7 Jasmine Run
Ormond Beach, FL 32174 USA
Phone: 386-437-8747, Fax: 386-437-8737, Cell: 386-316-5904
E-mail: [log in to unmask], Website: www.engelmaier.com
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|