Hello there,

This is marginally related to electronics, but hopefully someone on the
list has some relevant experience.

 

We are using some small Orings in some of our assemblies, just to keep
splashed water out, nothing really high pressure at all.  We need to
seat these Orings into a plastic well, which is slightly smaller than
the uncompressed OD of the Oring.  This is a bit of a hassle, especially
on the products where there are 20 Orings.

 

Has anyone developed any sort of a neat little compression and insertion
tool for Orings?  Any suggestions would be greatly appreciated!

 

Thanks,

Hal Winslow

Hwinslow at zoll.com


---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------