Content-Type: |
text/plain; charset="iso-8859-1" |
Sender: |
|
Subject: |
|
From: |
|
Date: |
Thu, 2 Dec 2004 08:57:58 -0800 |
MIME-Version: |
1.0 |
X-To: |
|
Reply-To: |
|
Parts/Attachments: |
|
|
Use hot tweezers.
-----Original Message-----
From: TechNet [mailto:[log in to unmask]]On Behalf Of Le Ai Quoc
Sent: Wednesday, December 01, 2004 8:57 PM
To: [log in to unmask]
Subject: [TN] 0201mil chip (0603mm) hot air rework method
Hi technetters,
Good morning!
Who among you here know how to use portable hot air rework method to repair
chip 0201 (0603mm). We use this equipment with non-flux solder wire.
We have some misalignment, tombstone at this chip and need to replace with
the new part. We had a portable hot air made by Hakko but to do this job,
actually it is very difficult. Normally, chip is blown away or solder wire
added to the electrode is too much.
What is the temperature profile for this chip? Because w/o profile, we don't
know the setting of temperature and hot air volume for this part when
reworked.
Thanks so much for your instruction,
Best regards,
Quoc
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|