Hi Technet,
I have a question about tooling for assembly of press fit connectors.
So far we have been assembling press fit parts with improvised tooling,
but since we're seeing more and more of these connectors we feel the
need to invest in more professional equipment for doing the assembly in
a more standardized and repeatable way.
I'm looking for recommendations on the type of tooling that can be used
for this. The volumes are low.
Best regards,
Daan Terstegge
PCB Assembly Department
Thales Land & Joint Systems
Tel +31(0)35 524 8297
Fax +31(0)35 524 8181
[log in to unmask]
Unclassified Email
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------