Subject: | |
From: | |
Reply To: | |
Date: | Thu, 4 Nov 2004 17:09:45 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Yannick,
I would advise that you go back to the OEM who designed the board to ask
them to have a requirement for "plugged" vias for those holes. It will
entail, typically, that they issue a mask layer with apertures for the
plug for those specific holes, and add a note to the print indicating
that there are plugged vias from Side 2 using mask artwork supplied. The
plug is not the same as "filling" - to totally fill the hole with
material is more difficult and more expensive (although technically
available). The least costly way out is with plugging with non-LPI
soldermask material from the back side of the via. There is one caveat: if
the board has an OSP for a surface finish it is not compatible with the
via plug process. In that case the vias will need to be filled with
material ... which gets into a larger discussion about how best to effect
that.
Good luck,
Valerie
ps: IPC is working on a complete guide (discussion, terms, guidance, etc.)
for the ways through holes can be "protected" (filled, capped, plugged
etc) but while it is close I don't think it is quite ready; you might want
to make yourself a note to check on it periodically.
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|