Sender: |
|
X-To: |
|
Date: |
Tue, 26 Oct 2004 12:05:13 -0500 |
Reply-To: |
|
Subject: |
|
MIME-Version: |
1.0 |
Content-Transfer-Encoding: |
7bit |
Content-Type: |
text/plain; charset="utf-8" |
From: |
|
Parts/Attachments: |
|
|
This discrepancy is due to the fact that the IPC does not do a good job of
'proofing' their documents prior to releasing them.
I have noticed this in other IPC Specs. (I.E. IPC-D-356B)
Regards,
James Jackson
Oztronics
----- Original Message -----
From: "Indrek Rebane" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Tuesday, October 26, 2004 11:59 AM
Subject: Re: [DC] Pin Numbering Question
> Hi George,
>
> According to IPC-7351 final draft (final is not released yet as far as I
> know) pin one is always positive and thus an anode for molded
> components. See Figure 16-1. But on same figure you see that for MELF,
> pin 1 is always "Polarity Mark" or cathode. Go figure!?
>
> Indrek
>
> George Patrick wrote:
> > According to Donna Robertson [[log in to unmask]] over on the Cadence
List:
> >
> > "If you are following IPC-7351 Pin 1 is the Cathode."
> >
> > DISCLAIMER: I don't have a copy, so I can't verify it :)
>
>
> --
> Indrek Rebane | Borthwick-Pignon
> Electronics Engineer | Tartu Science Park
> Phone: (+372) 7 302 641 | Riia 185, 51014 Tartu
> Fax: (+372) 7 383 041 | Estonia
> [log in to unmask] | www.bps.co.ee
>
> --------------------------------------------------------------------------
-------
> DesignerCouncil Mail List provided as a free service by IPC using LISTSERV
1.8d
> To unsubscribe, send a message to [log in to unmask] with following text in
> the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
> To temporarily stop/(restart) delivery of DesignerCouncil send: SET
DesignerCouncil NOMAIL/(MAIL)
> Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
> Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
> --------------------------------------------------------------------------
-------
>
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL)
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
---------------------------------------------------------------------------------
|
|
|