The most common cause I have found is very thin or voids in the plating. I
have two different boards that are sent from the PWB manuf. To another place
for silver immersion. One has a problem the other is fine. When we first
noticed this I looked down the barrels , and while I could not see any voids
I can clearly see the layers.
-----Original Message-----
From: Morse, Carrie [mailto:[log in to unmask]]
Sent: Friday, September 10, 2004 1:33 PM
To: [log in to unmask]
Subject: [TN] Blow Holes -- Where the heck does the moisture come from
anyway?
Just wondering a few things here at 2:30 on Friday Afternoon:
1. What else causes Blow Holes at wave on TH comps? Is it primarily
moisture?
2. Where does the moisture come from?
3. Are certain board materials more likely to sponge up the moisture in
the air?
4. Can hole wall quality play a part in contributing to blow holes?
-Carrie
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------