I believe the way it (federal code) is written you have to sample (or
guesstimate) to verify air quality is acceptable...and make sure this is
documented somehow...

For example, you document your flux emits vapors with 0.0002 mg/L arsenic
which is a hazardous substance...the level emitted is calculated by volume
used multiplied by time...etc etc and come up with some figure such as 1
pound each quarter which is below the lethal dose, etc etc etc...

It's been years since I've had to work in that arena...but I don't think
they've changed it too much...

Have I confused you yet...

Franklin

----- Original Message -----
From: "Joe Spicuzza" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Wednesday, September 08, 2004 1:18 PM
Subject: [TN] Air Quality Sampling


Does anyone know if there are federal requirements to take air samples in an
assembly shop, or are the guidelines at the state level? Any comments are
appreciated.

Joseph Spicuzza
Millennia Technology, Inc.
1105 Pittsburgh Street
Cheswick, PA 15024
724 274-2222
[log in to unmask]

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------