Sender: |
|
X-To: |
|
Date: |
Wed, 18 Aug 2004 10:03:28 -0400 |
Reply-To: |
|
Subject: |
|
From: |
|
X-cc: |
|
Content-Type: |
text/plain; charset="us-ascii" |
MIME-Version: |
1.0 |
Parts/Attachments: |
|
|
Cheryl,
I use a tool developed by Vitronics-Soltec. It holds nine pieces of foil
in a tic-tac-toe pattern. You weigh the foils dry, send the tool with
foils up the wave solder machine (flux and preheat on, wave off), and
re-weight the foils. You can average the foil weight and/or normalize the
data to get ug/in2.
The tic-tac-toe pattern also show how the flux is spraying side-to-side
and front-to-back. This can't be done by weighing a pcb or some of the
other commercially available tools.
I use the pallet monthly for SPC. I also used the pallet to run some
DoE's to understand and optimize your settings.
I co-authored a paper on this at APEX 2001.
Good luck,
Al Kreplick
Sr. Mfg. Eng.
Teradyne, Inc.
Cheryl Tulkoff <[log in to unmask]>
Sent by: TechNet <[log in to unmask]>
18/08/2004 09:26
Please respond to TechNet E-Mail Forum; Please respond to Cheryl Tulkoff
To: [log in to unmask]
cc:
Subject: [TN] Tool for measuring amount of flux applied
Can anyone recommend an accurate tool or method for measuring the amount
of liquid flux applied by a spray fluxer for the wave solder process?
Thanks!
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask]
or 847-509-9700 ext.5315
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
|
|
|