Preferred would be 1 up with panelization drawing.

I'm not familiar with the assembly, but I believe 1/4" would be the lowest
dimension you would want. Typical is 1/2"

Regards,

Damon A. DeSilva
Engineering Manager
Lazer-Tech Ltd.
PH#(416)291-7727 EXT:271
FAX(416)291-0325
[log in to unmask]


-----Original Message-----
From: TechNet [mailto:[log in to unmask]]On Behalf Of John Foster
Sent: Monday, July 12, 2004 2:32 PM
To: [log in to unmask]
Subject: [TN] Question about panelization


I have been doing a lot of layouts lately of very small boards. These boards
require panelization. I was wondering if I could get a idea of whether
fabricators
prefer to get gerber that is already panelized or whether they prefer
to just get the one up gerber with a drawing that shows the panelization.


Also I was wondering at what board size does it become a pain for assembly.
I always try to put .250 inch manufacturing rails on boards for the
conveyors.


I have been doing a lot of boards on the 1" x 2" size.

Any input would be appreciated.

Thank You

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------