Hello everyone, 

 

I am currently encountering a wave solder issue that I would like to ask
your opinion about.  I have a dual row connector (Molex part #
70246-1621) that accumulates soldering bridging in a group of three.  I
sent Steve an e-mail to see if he could post the picture on his website
so hopefully he can but until then I'll try and give you a generic idea
of how it is bridging.  (The "arrow's" below represent the bridging
between the leads)  The wave operator has tried different speeds and
board directions but continues to struggle with this particular
connector.  

 

 

                        

If anyone has any input I would appreciate it.

 

TIA,

 

Rich


---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------