TECHNET Archives

June 2004

TechNet@IPC.ORG
Options: Use Monospaced Font
Show Text Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
Re: clearance between two solder pads
From:
Lum Wee Mei <[log in to unmask]>
Reply To:
TechNet E-Mail Forum.
Date:
Wed, 23 Jun 2004 10:03:02 +0800
Content-Type:
text/plain
Parts/Attachments:
text/plain (54 lines) 
Alice,

Thanks. This table governs clearances for high voltage requirements.

Regards,
Wee Mei

Alice Peng wrote:

>Hi Wee Mei,
>
>This should be  minimum electrical clearance. Please see the attached file.
>
>Jack, would you confirm me if I'm right ot not.
>
>Alice
>----- Original Message -----
>From: "Lum Wee Mei" <[log in to unmask]>
>To: <[log in to unmask]>
>Sent: Tuesday, June 22, 2004 11:28 AM
>Subject: [TN] clearance between two solder pads
>
>
>
>
>>Hello,
>>
>>Out of curiousity, is there a recommended clearance between two
>>through-hole solder pads, assuming it is too small to run a trace through.
>>
>>Thanks and regards,
>>Wee Mei
>>
>>---------------------------------------------------
>>Technet Mail List provided as a service by IPC using LISTSERV 1.8e
>>To unsubscribe, send a message to [log in to unmask] with following text in
>>the BODY (NOT the subject field): SIGNOFF Technet
>>To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
>>To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
>>Search the archives of previous posts at: http://listserv.ipc.org/archives
>>Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
>>-----------------------------------------------------
>>

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------

ATOM RSS1 RSS2