Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Thu, 10 Jun 2004 13:30:44 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
We must keep 300 MIL (~7.5 mm) from 1206 size or greater non-leaded parts to
any scores unless we have drilled a series of small holes along the score
line so they are starting and ending 400 MIL (~10.1mm) either side of the
part. The holes are the same size as the top of the score. This drops to
150 MIL (~3.3mm) for non-leaded parts less than 1206 size.
--
George Patrick
Tektronix, Inc.
Central Engineering, PCB Design Group
P.O. Box 500, M/S 39-512
Beaverton, OR 97077-0001
Phone: 503-627-5272 Fax: 503-627-5587
http://www.tektronix.com http://www.pcb-designer.com
It's my opinion, not Tektronix'
-----Original Message-----
From: Barr, Bob [mailto:[log in to unmask]]
Sent: Thursday, June 10, 2004 12:20
To: [log in to unmask]
Subject: [TN] Subject: V-Groove Keep Out Area
I have been given a v-groove score keep out area dimension of 1mm from the
edge of the groove to the component body; except the dimension becomes 5mm
for ceramic components. 5mm seems like a very large value. Does anybody have
experience with this? Is it really necessary to keep ceramic components that
far from a v-groove score?
Thanks.
Bob
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
|
|
|