Jim
Well the soak time has mainly the effect of the strain brought into the
solder joint.
Regarding the strain rate during the soak time:
Yes, the stresses will be relieved. This means that during the soak the
strain rate is continuously become smaller until the theoretically
possible strain is induced into the solder joint. The influence of this
strain-rate / time behaviour is in my opinion rather difficult to
quantify. However, the strain rate in the dwell is factors smaller than
in the ramp and thus the influence on the degradation should be
negligible or at least the failure caused by the assumption that there
is no influence is within the spread of failures occurring in reality
and in tests.
Best regards
Guenter
EMPA
Swiss Federal Laboratories for Materials Testing and Research
Centre for Reliability
Guenter Grossmann, Senior Engineer
8600 Duebendorf
Switzerland
Phone: xx41 1 823 4279
Fax : xx41 1 823 4054
mail: [log in to unmask]
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------