Content-Type: |
text/plain; charset="iso-8859-1" |
Sender: |
|
Subject: |
|
From: |
|
Date: |
Fri, 11 Jun 2004 06:51:15 -0700 |
MIME-Version: |
1.0 |
X-To: |
|
Reply-To: |
|
Parts/Attachments: |
|
|
Hi Ken:
It is not a good practice. There may be parts like EPROMs or UVPROMs on the board that may be affected by the magnetic flux. Although some of the test technicians claim that the flux from a screw driver is not strong enough to cause any damage.
To be on the safe side use clip screw divers instead.
Regards,
Ramon
-----Original Message-----
From: Bloomquist, Ken [mailto:[log in to unmask]]
Sent: Thursday, June 10, 2004 4:47 PM
To: [log in to unmask]
Subject: [TN] Magnetic Screwdrivers
This is my second question today. I hope that's ok and I'm not over my limit ;-)
We have a person asking if it's OK to use magnetic tipped screwdrivers to assembly our products. We don't have any floppy or hard drives in them but we do have lots of active components. My feeling is that there is no problem but I thought I'd as just for piece of mind.
Thanks and thanks for the quick response on my earlier fire retardant question, you people are great!!
KennyB
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
|
|
|