Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 16 Apr 2004 14:01:02 EDT |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi Joe!
If I tell ya', what will ya' give me? Just kidding!
Go to: http://www.pdr-smt.com/X210.html
I've got their high-end BGA/SMT rework station, and I can say without
hesitation, it's the best rework station I've ever used.
-Steve Gregory-
> Fellow TechNets,
>
> For hand installation / rework of small components such as 0603 sized, QFN
> odd-form type parts, we have been using various hot air type tools. The
> operators complain that sometimes they have to hold the parts with tweezers
> so that the air does not moves the parts around enough to cause problems.
> If they turn the air down far enough to eliminate this problem than not
> enough heat is transferred to the part/board to reflow the solder - most of
> our boards are double sided with a lot of copper in them.
>
> Would someone please direct me to a source of some type of small, IR type of
> hand-held rework tool. Does such a tool exist? Look forward to any help on
> this. thanks
>
> joe
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
|
|
|