It's a great question, Kelly.
Seems like every way I've seen it, it's open to interpretation. Does a
plane area still have a "trace width"?
If the drawing says +/- 10%, does that mean the fabricator takes 10% of the
smallest trace on the board and uses that number everywhere? Or does it
apply to each width?
Better yet, I've seen it as a trace/space tolerance. If a minimum trace is
routed at minimum space anywhere, any deviation is a violation of one or
the other.
I know, I know... That really just didn't help at all....
"Dack.Kelly"
<[log in to unmask]> To: [log in to unmask]
Sent by: DesignerCouncil cc:
<[log in to unmask]> Subject: [DC] Etching Plating
tolerance specs...
04/26/2004 12:58 PM
Please respond to
"(Designers Council
Forum)"; Please respond to
"Dack.Kelly"
Greetings,
An inconsistency in our fab specs regarding etching/plating tolerance finds
me at a mental "cross-roads" regarding this subject.
The spec for some of our designs express the tolerance in the form of
"mils"
-- +/-.001, while other spec express the tolerance in the form of a
percentage -- +/-10%.
In one sense, on a design w/ .010 nominal lines and spacing, these two
specs
are the same. However, on a design w/ .005/.005 or .004/.004 lines and
spacing, using a tolerancing method of +/-.001 vs. 10% has drastically
different results.
I would like to see any feedback on the pro's and con's of each method.
What
method do you use and why?
-- Kelly
Kelly Dack
PCB Dsnr
IGT (International Game Technology)
Reno, NV
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV
1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To set a vacation stop for delivery of DesignerCouncil send: SET
DesignerCouncil NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
---------------------------------------------------------------------------------
"This e-mail message is intended only for the use of the intended
recipient(s).
The information contained therein may be confidential or privileged, and
its disclosure or reproduction is strictly prohibited.
If you are not the intended recipient, please return it immediately to its
sender at the above address and destroy it."
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To set a vacation stop for delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
