Greetings,

An inconsistency in our fab specs regarding etching/plating tolerance finds
me at a mental "cross-roads" regarding this subject.

The spec for some of our designs express the tolerance in the form of "mils"
--  +/-.001, while other spec express the tolerance in the form of a
percentage -- +/-10%.

In one sense, on a design w/ .010 nominal lines and spacing, these two specs
are the same. However, on a design w/ .005/.005 or .004/.004 lines and
spacing, using a tolerancing method of +/-.001 vs. 10% has drastically
different results.

I would like to see any feedback on the pro's and con's of each method. What
method do you use and why?

-- Kelly

Kelly Dack
PCB Dsnr
IGT (International Game Technology)
Reno, NV

---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To set a vacation stop for delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------