Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Mon, 29 Mar 2004 12:07:36 -0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Victor:
The press fit connector manufacturer should recommend the nominal barrel diameter and tolerances for the connector you are using. I do not know what type of connector pins you are using, but the ones I have seen have an eye shape part of the pin that acts as a spring and puts pressure on opposite sides of the barrel walls to create a cold solder fusion between the pin and the barrel.
Regards,
Ramon
-----Original Message-----
From: Victor G. Hernandez [SMTP:[log in to unmask]]
Sent: Monday, March 29, 2004 2:04 PM
To: [log in to unmask]
Subject: [TN] Press Fit Connector / Leads
Fellow TechNetters,
Can someone guide me to an IPC document that make reference to Press
Fit Connector
and/or Leads onto PWB wth respect to ROUND, RECTANGULAR and SQUARE
Leads. I have a
case in which the square lead scffieiently deformed the barrel wall and
has a small
amount od solder fillet.
In advance I thank you for your timely response in this matter.
Victor,
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives <http://listserv.ipc.org/archives>
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 <http://www.ipc.org/contentpage.asp?Pageid=4.3.16> for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
|
|
|