Good afternoon,

Can someone please help me with clarification of IPC-A-610 Section 6.9. 1)
If solder wicks up the pin more than 2.5 mm. but the pin is non-functional -
i.e. this is a female thru-hole connector so the mating connector goes on
the component side and the pins stick thru on the solder side, why is this
an issue. The problem we are having is the pins are on very tight centers -
stick thru the part over an inch and we have to hand solder. Thanks in
advance for the help. Regards Steve Kelly

 

PFC Flexible Circuits Limited

Ph: (416) 750-8433

Fax: (416) 750-0016

Cell: (416) 577-8433

E-Mail: [log in to unmask]

 


---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------