Hi Technet,

Any recommendation on a vision inspection system for components (placement
and value) as well as solderjoints quality?
Will consider all suggestions, in-line/stand-alone.
Also be interested on hearing the Pros and Cons.

Thanks in advance.

Regards;

Francis Sun
MARK IV Industries
(905) 624-3025 ext. 1235
Fax: (905) 624-4572
NOTE: This e-mail is intended only for the named recipient(s) above and may
contain information that is proprietary, confidential and/or exempt from
disclosure under applicable law. If you have received this message in
error, or are not the named recipient(s), please immediately notify the
sender via e-mail or call 905-624-3020 and delete this e-mail message.

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------