Gents,

I'm looking to replace an existing dip conformal coating m/c.  We're a
low/medium volume military establishment that spends an awful lot of time
masking up various boards.
I once saw a spray coating m/c in operation (several years ago!) and it
looked pretty slick, the engineer stated that manual masking was redundant
as the operation was carried out modifying the CAM data. If I remember
correctly the equipment was supposed to be accurate to ~1mm during the
spraying operation, is this correct / typical?
I'm looking for the pro's & con's of these systems, approximate cost of one
of these was bearing in mind through put is not an issue & suppliers,
ideally in the UK but not tied to this.

CIA,
        Iain.

********************************************************************
This email and any attachments are confidential to the intended
recipient and may also be privileged. If you are not the intended
recipient please delete it from your system and notify the sender.
You should not copy it or use it for any purpose nor disclose or
distribute its contents to any other person.
********************************************************************

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------