Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Thu, 15 Jan 2004 19:03:56 +0000 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Ken
Whilst Bellcore remains extant, it really isn't up to date. You might want
to quote ISO-PWI 9455-17 compliant.
This is a new International Standard that was mirroring the revision to
IPC-J-STD-004. Unfortunately, the revision has not yet been approved for
release.
Hope this helps
--
Regards Graham Naisbitt
[log in to unmask]
Cell: 079 6858 2121
Office: +44 (0)1252 813706
Concoat Limited - Engineering Reliability in Electronics
NEW - HumiSeal 1H2O Bov Aerosol - NEW
Web: www.concoat.co.uk and www.concoatsystems.com
> Experts,
>
> If I have to allow my CM to use No Clean solder paste, what kind of note
> should I put on assembly drawing (with some kind of qualification
> requirement)? Our product is for telecom/networking industry so I rather
> specify some kind of qualification requirements (if any) than just write -
> use no clean solder paste. I know all pastes are not same and may not be
> suitable for certain industry.
>
>
>
> I used to put a note on my assembly drawing for hand soldering something
> like...
>
>
>
> HAND SOLDER FOLLOWING COMPONENTS USING TELCORDIA (BELCORE) COMPLIANT
> NO-CLEAN FLUX.
>
>
>
> Any help will be appreciated. Thanking you in advance.
>
>
>
> Re,
>
> Ken Patel
>
>
> ---------------------------------------------------
> Technet Mail List provided as a service by IPC using LISTSERV 1.8e
> To unsubscribe, send a message to [log in to unmask] with following text in
> the BODY (NOT the subject field): SIGNOFF Technet
> To temporarily halt or (re-start) delivery of Technet send e-mail to
> [log in to unmask]: SET Technet NOMAIL or (MAIL)
> To receive ONE mailing per day of all the posts: send e-mail to
> [log in to unmask]: SET Technet Digest
> Search the archives of previous posts at: http://listserv.ipc.org/archives
> Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for
> additional information, or contact Keach Sasamori at [log in to unmask] or
> 847-509-9700 ext.5315
> -----------------------------------------------------
>
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
|
|
|