Experts,

If I have to allow my CM to use No Clean solder paste, what kind of note
should I put on assembly drawing (with some kind of qualification
requirement)? Our product is for telecom/networking industry so I rather
specify some kind of qualification requirements (if any) than just write -
use no clean solder paste. I know all pastes are not same and may not be
suitable for certain industry.



I used to put a note on my assembly drawing for hand soldering something
like...



HAND SOLDER FOLLOWING COMPONENTS USING TELCORDIA (BELCORE) COMPLIANT
NO-CLEAN FLUX.



Any help will be appreciated. Thanking you in advance.



Re,

Ken Patel


---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------