Sender: |
|
X-To: |
|
Date: |
Fri, 23 Jan 2004 11:54:02 +1100 |
Reply-To: |
|
Subject: |
|
MIME-Version: |
1.0 |
Content-Transfer-Encoding: |
quoted-printable |
Content-Type: |
text/plain; charset="us-ascii" |
From: |
|
Parts/Attachments: |
|
|
I've recently specified dry film solder mask on a production board.
I normally ask for LPI.
The only reason being that I couldn't rely on LPI to reliably tent every
via.
The badly tented vias could not pick up solder and fill adequately to
comform to the Class 2 requirements, creating reliability concerns.
Ideally, I would like the vias filled and then tented with LPI, but our
fab shops here in Australia don't do the via filling.
regards,
Phil Dutton.
-----Original Message-----
From: Steve Gregory [mailto:[log in to unmask]]
Sent: Thursday, 22 January 2004 11:47 AM
To: [log in to unmask]
Subject: [TN] Why Dry film Solder Masks?
Can anybody tell me why dry film solder masks are still specified?
I don't want to hear; "Because they've always worked good..."
But some clear, concise, reasons for specifying them...
Vacuum at ICT is a dead deal, there are ways to deal with open via's
with
LPI's...Solder fill for via's is a dead deal...either you fill them, or
you don't.
So why dry-films?
So many complications come up with dry film solder masks...
Not only for the bare board manufacturer...but also for the assembler.
Just a question...(for the DoD guys, especially)
-Steve Gregory-
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text
in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at:
http://listserv.ipc.org/archives
Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
|
|
|