Hi all,

I need help on an exiting new project for us.
We are going to make a 4 layer flexible board with double sided SMT.
It is going to be an L shaped board and its size will be approximately
45x30x0.4mm
The smallest components will be 0402 and there will probably go 10 boards
in a flat.
We are thinking about a Rigid carrier with the possibility to clamp all
four sides but we are not sure on how the stress of clamping (stretching)
the board will affect the boards (placement accuracy)

I would like suggestions on how to handle the boards during SMT placement.
I'm sure there are more companies that are performing this kind of
assembly.
All suggestions are welcome.
Maybe you can show me the holes I don't want to step into.


Hilbrand Molema
E-MAIL [log in to unmask]

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------