The IPC 7711 and 7721 may address the repair and rework conditions you refer
to.  I think it's safe to say that services charges are determined by the
particular vendor who would provide the service.  They probably vary from
vendor to vendor.
Charley

-----Original Message-----
From: Guy Ramsey [mailto:[log in to unmask]]
Sent: Wednesday, December 31, 2003 9:09 AM
To: [log in to unmask]
Subject: Re: [TN] rework/repair cost


I don't remember an IPC document with information like that.
There is a list of defects in the IPC-7912 and IPC-9261. They are needed
for DPMO calculations. Defects must be associated with the component,
the placement, the termination, or the assembly. For example, a solder
bridge is a termination defect while a solder balls and splashes are
assembly defects.
Wish I could help with cost. This link might help. It give retail $$
values for services. http://www.circuittechctr.com/services/terms.shtml


> -----Original Message-----
> From: TechNet [mailto:[log in to unmask]] On Behalf Of Suzanne Foulkes
> Sent: Tuesday, December 30, 2003 3:20 PM
> To: [log in to unmask]
> Subject: [TN]
>
>
> I've just started a new position with a new company. I am
> establishing defect codes and my old boss had cost associated
> with them. I was told it came from IPC. Does anyone have this
> document or can you tell me where to find it? For example the
> cost to repair a board with a missing part was 1.10,
> tombstoning was.12, Pad Damaged was 12.77.
>

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------