Mike,
My experience is the most accurate would be at primary drill rather than
secondary, of course
most drill machines have limitations to drill
hole size diameter, usually around .250 in. which you are forced to do a
secondary either by peck drill or routed out-you also have limitations on
resist tenting if you primary drill large diameter holes.
----- Original Message -----
From: "Mike Larson - ID" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Friday, November 07, 2003 4:31 PM
Subject: [TN] Question for Pcb fabricators


> What is the tightest tolerance that can be held on a non-plated hole
> relative to the fine pitch artwork pattern on one of the external layers,
> this could be a dimension od around an inch to 5 inches approximately  I
am
> trying to locate a hole within +/-.0015" of a artwork pad that is sized
> .006"x.098" , this is connector pattern of around 300 to 400 pads at a
pitch
> of .31mm
>
> Which method of drilling would work best for this, primary drill operation
> or a secondary drill after the outer layer has been etched?  The pcbs are
> both rigid and rigid flex polyimide class 3 designs.
>
> Thanks in advance,
>
> Mike
>
> ---------------------------------------------------
> Technet Mail List provided as a service by IPC using LISTSERV 1.8e
> To unsubscribe, send a message to [log in to unmask] with following text in
> the BODY (NOT the subject field): SIGNOFF Technet
> To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
> To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
> Search the archives of previous posts at: http://listserv.ipc.org/archives
> Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
> -----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------