Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 5 Nov 2003 08:50:57 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Kathy,
I have no tolerance at all for someone who would counterbore a perfectly
good PWB.Seriously,I don't allow it because it is a post-processing
operation(very expensive to scrap then) and hard to define and measure due
to a lot of variables.
Dewey
> -----Original Message-----
> From: Kathy Bergman [SMTP:[log in to unmask]]
> Sent: Monday, November 03, 2003 3:46 PM
> To: [log in to unmask]
> Subject: [TN] Counterbore depth tolerance
>
> Hello Netters,
>
> Any ideas of what a standard depth tolerance of a typical counterbore on a
> PCB might be?
>
> Thanks
> K Bergman
>
> ---------------------------------------------------
> Technet Mail List provided as a service by IPC using LISTSERV 1.8e
> To unsubscribe, send a message to [log in to unmask] with following text in
> the BODY (NOT the subject field): SIGNOFF Technet
> To temporarily halt or (re-start) delivery of Technet send e-mail to
> [log in to unmask]: SET Technet NOMAIL or (MAIL)
> To receive ONE mailing per day of all the posts: send e-mail to
> [log in to unmask]: SET Technet Digest
> Search the archives of previous posts at: http://listserv.ipc.org/archives
> Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
> for additional information, or contact Keach Sasamori at [log in to unmask] or
> 847-509-9700 ext.5315
> -----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
|
|
|