Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Mon, 20 Oct 2003 11:20:13 EDT |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi Jim,
>Are there any sort of industry standards which define the following tests:
> a. three point bend test
No
> b. four point bend test
Not yet, 6-10d is working on it together with JEDEC. There likely will be
separate TMs for "Monotonic Bending" [purpose is to find 'brittle' interfacial
solder joint failures resulting from low interfacial/metallization strength] and
"Dynamic Bending" [similar to the IEEE CLTF test for the purpose to fatigue
SJs similar to T-cycling--it works to some degree]
> c. ball shear test
No, there should not be one, because the strength values are meaningless,
only the failure mode is telling.
> d. board level torsion test
No, see (c)
Regards,
Werner Engelmaier
Engelmaier Associates, L.C.
Electronic Packaging, Interconnection and Reliability Consulting
7 Jasmine Run
Ormond Beach, FL 32174 USA
Phone: 386-437-8747, Fax: 386-437-8737, Cell: 386-316-5904
E-mail: [log in to unmask], Website: www.engelmaier.com
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
|
|
|