Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Tue, 23 Sep 2003 15:57:19 +0300 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hello,
In IPC-2221, page 39, Table 6.1 is about the Electrical Conductor
Spacing. While designing a PCB with high voltage (1000 V), according to
the standart the layer-to-layer thickness and trace-to-trace clearance
is 1.5 mm (For Internal Conductors). Is this requirement is needed just
for dielectric material FR4 or for all dielectric materials table 6.1
restrictions are applicable? If not, could you please inform me about
the thickness change with the dielectric constant? And the materials for
boards with high voltage?
Actually on page 39, it is written that "When employing high voltages
and especially AC and pulsed voltages greater than 200 volts potential,
the dielectric constant and capacitive division effect of the material
must be considered in conjuction with the recommended spacing."
However there is no other information about the table 6.1. Is this table
prepared for FR4 or not?
Best Regards
Thanks in advance
Sefika Ozkal
Electronics Engineer
ASELSAN Inc.
Microelectronics, Guidance and Electro-Optics Division
Electronic Design
Address : P.O. Box:30, Etlik 06011 Ankara,TURKEY
Tel :+90 312 847 53 00 Ext:4698
Fax :+90 312 847 53 20
e-mail : [log in to unmask]
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
|
|
|