Phil,

A Goggle search turned up the following:

http://www.tohnichi.com/whatsnew4.html

This is neat. Never knew this type of thing existed. We do not mark hardware
that has been torqued.

=========================
Bob Barr
Manufacturing Engineering
Formation, Inc.
=========================

> -----Original Message-----
> From: Phil Nutting [mailto:[log in to unmask]]
> Sent: Thursday, August 07, 2003 12:49 PM
> To: [log in to unmask]
> Subject: [TN] marking screws at torque step
>
>
> Good afternoon,
>
> Does anyone have the requirement to mark hardware that has
> been set to a specific torque?  We currently use an air
> driven driver and then follow with a paint marking pen.  Is
> there a tool on the market that can torque and mark the
> hardware in one step?  Torque range typically 6 inLb to 50
> inLb, hardware type either Phillips head or hex head.
>
> Thanks in advance.
>
> Phil Nutting
>
>

---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------