Hello technet.
I have a question on PCB design. We are redesigning our board and a
question came up that I am unable to verify. We are looking at having a
plated through-hole near the end of the board. This plated through hole
will be used to place a post through and soldered into place for
electrical contact.
The question that I have is as follows,
? Is there a requirement indicating that an annular ring is to be a
certain diameter larger than the actual through hole? And how far from
the edge of board should an annular ring be placed?
Thanks for your help.
---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------