No I would not use sr1000 if I possible could  as a pcb manufacturer.
possibly i would use it as a filler for filed vias but there are new oven
cured masks I like better. however the new Photo imagble solder mask is very
good, much harder then sr1000 and features higher dialectric.

If you specify a extra UV curing cycle ( check with manufacturer first)but a
uv cure realy creates a hard durable mask. with fine edge detail and no surface
contamination.

---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------