Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Tue, 13 May 2003 11:32:38 +1200 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi Technetters,
looking through the Technet archives on the differences between HASL and ENIG
boards, I notice that higher temeperatures are required for soldering ENIG boards.
Presumably this is because the gold layer firstly has to be dissolved, and we are
dealing with a Ni/Sn intermetallic rather than a Cu/Sn intermetallic.
Does anyone have any recommendations on what differences have to be made to the
reflow profile (e.g. different times above 183 deg C or 200 deg C)? Or can the same
profile be used for the same board regardless of whether it is HASL or ENIG?
Thanks in advance for any replies.
Regards,
Chris Murphy,
Production Engineering,
Tait Electronics
---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
|
|
|