Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Thu, 29 May 2003 05:46:27 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Gusti,
This is a terrible idea. Contamination can and will be trapped in the coating as it melts/softens
above Tg. The coating itself can become "carbonized" in the heat from the soldering iron.
The coating thickness will change dramatically, exceeding the manufacturers recomendation.
Mostly it is messy and uncontrollable.
If your end use environment requires the use of a protective coating then
burning/melting it to save time is just plain wrong!!
David A. Douthit
Manager
LoCan LLC
Augustin Stan wrote:
> Hi TechNet’s,
> I am in the situation to reduce time consuming with masking and de-masking
> a couple of pads for an assembly covered with an acrylic lacquer. I am
> asking if someone have tried to solder by hand a component (with gull-wing
> terminals) without remove the conformal coating. I have experimented and
> observed that it can be done. It is a silly question or not?
> Any reaction will be welcomed.
> Gusti
>
> ---------------------------------------------------
> Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
> To unsubscribe, send a message to [log in to unmask] with following text in
> the BODY (NOT the subject field): SIGNOFF Technet
> To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
> To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
> Search the archives of previous posts at: http://listserv.ipc.org/archives
> Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
> information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
> -----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
|
|
|