Hello,
Have somebody used MLF components?
Product management is requesting to change some components to this type of
package.
The component has a 0.5 mm pitch.
I found some information in the attached link, it is recommending to use a
0.125mm (5 mil) stencil to print solder paste for this component.
http://www.amkor.com/products/notes_papers/MLF_AppNote_0902.pdf
Is it necessary to use this type of stencil with this component?
Regards,
Alejandro Becerra
---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------