Any of you guys know how to measure board warpage after the unit has been completely process?
Process:
SMT Bottom
SMT Top
PTH Axial and Radial
Hand loaded
Wave Solder
Post wave processing
At my Incoming receiving area I can detect board warpage but after the wave process (sometimes SMT Top) the boards start to warp. All the profiles have been verified and validated.
We know we have a vender issue but the problem is our customer will not accept the unit we have in process (around 500). So if anyone has any suggestions it would be greatly appreciated.
Carl Ray
Sr. Manufacturing Engineer
Huntsville, AL 35807
Phone: 256-882-4800 ext. 8845
Cell: 256-990-1990
---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------