Morning all
I have a question regarding Aperture List for Gerber Data. This is an area
I know little about so bare with me.
We had an incident with a PCB house which resulted in the boards being
manufactured with all traces/pads 0.020" bigger then they were supposed to
be. The shop said the problem arouse do to the way the aperture list was
set up.
The list has a set of 24 station #s with dimensions (which I understand get
translated to d-codes). These Station#s are then repeated further down
plus have extra #s to 999. We noticed that some of the dimensions in the
2nd set of station #s are differant from the 1st set. The 2nd set are the
correct #s.
The shop tells us their software (Infinite Graphics) will import the 1st
set then ignore the 2nd set of repeated #s then will continue to import any
station #s that are differant.
When we look at the Data with GC-Place and look at the used Apertures we
get the correct values.
Could the error be due to a differance in the way the software interprets
the list?..
The customer's data was created using P-Cad at least 10 years ago. The
format the Lists are in are the same for all the customers product. A
previous PCB shop had no reported difficulty.
Any ideas would be helpful
Thanks
Andre
---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------