I have a board 3.7" wide by 5.0" long that is .031" thick. In your
experience, is this board too wide to process on a conveyorized line without
warping? Is a fixture required? This is a double-sided board so it will see
two passes through printing, p&p and reflow. I am told by another party that
I should not exceed about 2.5" in width. This is the first time we are
working with a thin board such as this so I am not sure if this rule is true
or not. Any other issues I should watch out for? Thanks.
Bob
---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------