Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 31 Jan 2003 12:11:56 -0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
I've seen it done with a laser apparatus that maps the contour of the surface. I had it done annually. Wear on the surface can change the flatness/contour of the surface. Try to minimize wear by keeping it covered with something non-abrasive and not letting people use it for storage space.
Best Regards,
Timothy Reeves
Technical Service Engineer - Matsushita Electronic Materials, Inc.
4114 Heather Street, Forest Grove, Oregon, 97116
Main (503) 357-8695 Direct (503) 992-5109 Cell (503) 781-1495 Fax (503) 357-8868
-----Original Message-----
From: Franklin D Asbell [mailto:[log in to unmask]]
Sent: Thursday, January 30, 2003 7:57 AM
Subject: Calibration/Verification of granite-surface block
Can anyone describe to me the method of calibrating/verifying a surface
block???
Also, in regards to calibration recall, would this need to be on a recall
list or would it be verify it once in it's lifetime, what would be a cause
of initial calibration being voided...
Thanks,
Franklin D Asbell
---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
|
|
|