Hello technetters,
I've got the opportunity to adjust the layout in the Surface Mount Assembly
area.
A very interesting discussion has started.
Is it smart to place the lines in such a matter that the frontsides of 2
lines are facing each other?
I'm talking about 4 productionlines. So 2 lines will start at one end of the
room and the other 2 lines at the other end of the room.
Issues as logistics and "number of operators needed" are discussed.
This proposal comes from productionmanagement.
And I cannot be convinced in the "advantages" of such a layout.
Is there anyone who actually uses such a layout?
Are there really advantages in the daily practice?
Any comment on this subject is highly appreciated.
Thanks in advance
Jowan Iven
Process Engineer
Dept. Engineering & Technology
Stork Electronics BV
---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------