Hi TechNetters,

My company have set up a PCB prototyping Lab, with a Rapid PCB Prototyping
machine. It works good on routing and laminating, but when it comes to through
hole plating, it's a nightmare. The Quick Plate System just couldn't do a
reasonable plating job. I doubt if the process it uses to replace the
electroless plating really works. I would appreciate any suggestions to improve
it, or what can we get to replace this Quick Plat System.

Thanks,

Patrick
This e-mail may contain SEL confidential information.  The opinions expressed
are not necessarily those of SEL.  Any unauthorized disclosure, distribution or
other use is prohibited.  If you received this e-mail in error, please notify
the sender, permanently delete it, and destroy any printout.  Thank you.

---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------