Hello to all
I am looking for Information's about Rigid- Flex technologies.
The normal used Polyimidtechnologies are very expensive compared to Rigid
Boards.
Is there a "Low Cost" Solution?
We are in discussion about a product in which the flex- part is bended only
during mounting, not during the product is used.
Has anybody experience with such a solution, where can I get information?
Siggi
----------------------------------------------------------------------------
-
Kind regards / Mit freundlichen Grüßen
Dr. Siegmund Zweigart
New Technology Manager
Solectron GmbH
Solectronstrasse 2 Fon. ++49 7032 998 194
D - 71083 Herrenberg Fax ++49 7032 998 222
e-mail: [log in to unmask] <mailto:[log in to unmask]>
internet: www.solectron.com <http://www.solectron.com>
----------------------------------------------------------------------------
-
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------