TECHNET Archives

September 2002

TechNet@IPC.ORG

Options: Use Monospaced Font
Show Text Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
From:
Eddie Rocha <[log in to unmask]>
Reply To:
Date:
Thu, 12 Sep 2002 11:02:03 -0700
Content-Type:
text/plain
Parts/Attachments:
text/plain (18 lines)
For plated thru holes, a typical tolerance is +/-.003" . Now if we're
talking about vias ( where no leads are to be inserted) the tolerance
should not be critical, so a tolerance of +.003 / - (the diameter) is
what I always recommend. This allows the fabricator to choose the
most cost effective drill diameter for the associated pad.
Hope this helps,

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------

ATOM RSS1 RSS2