Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 30 Aug 2002 12:07:26 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Peter,
.035" is a good "min" to prevent shadowing on the chip comps, but, I have seen them right up against each other and soldering well with a chip wave.
.060" is a good "min" for through-hole lead to pad.
Don't forget to consider your placement equipment capabilities!
-----Original Message-----
From: Peter Lee [mailto:[log in to unmask]]
Sent: Friday, August 30, 2002 10:34 AM
To: [log in to unmask]
Subject: [TN] Wave soldering SMT component spacing
Technets,
Does anyone have guidelines on minimum SMT component spacing for bottom
sided wave soldering?
I am looking for general rule of thumb in wave soldering bottom side
SOTs, 0805 & 0603s.
How about minimum through-hole lead to pad distance?
Rgds,
Peter
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
|
|