Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Thu, 8 Aug 2002 16:09:17 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Good flex circuit drawings should follow the same guidelines as rigid
board drawings - i.e. use IPC specs for the material call-outs -
IPC-4202/4203 and 4204. Do a detailed layer stack. Detail the finish -
i.e. HASL , Gold or Immersion Tin with the appropriate specs and do a
very detailed dimensioned drawing with the 0,0 start position from a
hole centre or artwork feature - not off an edge. Specifications for the
material thickness tolerances are in the above mentioned IPC specs but
most of the vendors easily surpass the tolerances. Regards Steve Kelly
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Roseann Strength
Sent: Wednesday, August 07, 2002 5:08 PM
To: [log in to unmask]
Subject: [TN] flex circuit specs
Can anyone refer me to specifications for fabrication drawings for flex
circuits?
I did not find any board thickness tolerancing for thin flexible
circuits IPC-D-300G (using 1/2 mil construction).
Also, is there a 'standard' guideline for flex fab drawings?
Thanks
------------------------------------------------------------------------
---------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text
in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at:
http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for
additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
------------------------------------------------------------------------
---------
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
|
|